Category Archives: Uncategorized

Been a while, but I’m still working on things!

So, went out on the 26th and checked on the hubs. Got the snaprings off, then soaked them with some PB Blaster… Out again on the 27th, a couple of taps and I had this: Took them both off, here’s … Continue reading

Posted in Uncategorized | Leave a comment

Cleaned up the transaxle some…

Found my fingernail brushes out in the garage this afternoon, after giving Littletractor a Christmas oil change I thought I’d do a bit more cleanup on Bror’s transaxle… Here’s a before-and-after (sorta) for you all!The BIG question tho, is STILL … Continue reading

Posted in Uncategorized | Tagged , , , | Leave a comment

The Transaxle Removal Plan

Just spent an hour and a half or so out in the garage strategizing how to do this WITHOUT the cool stand, and I THINK I’ve got it figured out… 1. Jack up the back end, then place the jackstands … Continue reading

Posted in Uncategorized | Leave a comment

Argh!!! One step forward, two steps back!

So, I went out tonight, did up the bolts on the battery case, popped the gas tank on, got the fuel line connected, then put my battery in… Followed the manual and ran a lead from the battery terminal of … Continue reading

Posted in Uncategorized | Leave a comment

Whoo HOO! Found the bolts!

Whoo hooo!! Found the flywheel shroud bolts! Okay, moving on… Out to get some sort of Never-Seize to coat the flywheel shaft with! (the bolts were stuck in the bag with the governor bits!)

Posted in Bror, Uncategorized | Leave a comment

What I got done this weekend!

Well, totally crazy weekend, running kids around here and there, but wound up going out to Greensail’s place to pull some bits off a donor RF 110 (no pics of those yet, but thanks for letting me come out and … Continue reading

Posted in Uncategorized | Leave a comment

Last Night’s Work….

So, as promised, some more pictures about what I got done last night….First thing I did was go after Donor Frank to pull some bits out…. On the downside, after I pulled the cylinder cover off to get at the … Continue reading

Posted in Bror, Uncategorized | Leave a comment

The drift question, answered….

Originally Posted by biker3777  set the punch on the end of the rod bolt and tap it.I just use a plastic hammer to tap the rod cap on the side just make sure it is not bound up. Quote: Originally Posted … Continue reading

Posted in Uncategorized | Leave a comment

Did the honing tonight… I hope…

So, I screwed up my courage tonight, and hopefully DIDN’T screw up my cylinder.  Hopefully I followed all the MTF advice I got well enough… So, what do you all think? Still some marks on the cylinder wall where the … Continue reading

Posted in Uncategorized | Leave a comment

Here’s my place in Vegas

Posted in Uncategorized | Leave a comment